Screw encapsulation
Each screw head is sealed which stops fastener leaks.
Metal Roofing
Metal Roof Coating North Arlington, NJ
A metal roof coating in North Arlington can extend the life of panels that are still structurally sound but rusting, chalking or leaking at the fasteners, instead of a full tear-off. Call (551) 348-7205 to reach a local roofer.
A metal roof coating is a thick, flexible membrane rolled or sprayed over the panels, and it works best on a roof that is worn but still solid. Coatings target the common aging problems of metal: worn paint, surface rust, leaking fasteners and open laps. What a coating cannot do is fix rust holes, rotted framing or panels that are loose, so those are repaired first.
The two common chemistries for metal roofs are acrylic and silicone, each with strengths. Acrylics are flexible, reflective and recoatable, and they suit sloped metal that sheds water quickly. Silicone handles ponding water and UV well but bonds poorly to anything but more silicone later.
Most coating failures come from skipped prep, not bad material. Cleaning, rust treatment, fastener sealing and seam reinforcement all happen before the first coat. The work needs a stretch of dry, mild weather.
If the problem goes deeper than it first looked, a North Arlington roofer may also recommend metal roof repair or roof coating.
Need metal roof coating in North Arlington? Call (551) 348-7205 and describe the problem to a roofer who works in North Arlington.
Call nowThe process
The metal roof coating process
Here is how a roofer usually coats a metal roof.
Assess the candidate
The inspection rules out rust holes, loose panels and structural problems. Test patches help pick the right primer.
Wash the roof
Chalk and dirt are washed off so the coating bonds to the metal. Drying time depends on weather.
Prime the metal
Rusted areas are wire brushed and primed with a rust-inhibiting primer. Primer choice depends on the metal and the coating.
Seal fasteners
Fasteners, seams, penetrations and flashing get a heavy detail coat with reinforcing fabric. Penetrations and pipe boots get the same treatment.
Topcoat
Coats are sprayed or rolled on and checked with a wet film gauge. Correct thickness is what gives a coating its life span.
What is included
A complete metal coating job
Lap sealing
Seams and laps get fabric and coating with embedded polyester fabric.
Roof cleaning
The roof is washed and degreased for good adhesion.
Metal priming
Rusted areas are treated with inhibitor to stop corrosion under the coating.
Reflective coating
A reflective topcoat finishes the system and helps keep the building cooler.
Related service
Metal Roof Restoration North Arlington, NJ
A metal roof restoration combines repairs and a coating system to give a tired roof another long run. It typically includes replacing rusted-through panels, swapping worn fasteners, resealing laps, fixing trim and flashing and then applying the coating.
For a North Arlington building with a sound frame and worn metal, restoration is often a practical alternative to a tear-off. It avoids tear-off debris and keeps the building in use during the work. Ask the roofer which repairs are needed before coating and how thick the coating will be.
Related service
Metal Roof Painting North Arlington, NJ
Metal roof painting is a lighter job than coating, aimed at restoring color and rust protection rather than sealing leaks. Paint is much thinner than an elastomeric coating, so it will not bridge open laps or seal leaking fasteners.
A North Arlington roof with good fasteners and sound seams can be painted for color and protection. The surface still has to be cleaned of chalk and rust primed first, or the paint will peel. For roofs with leaks, ask about a full coating instead of paint.
Local help
Metal Roof Coating Near Me
Around North Arlington, coatings are often chosen for metal roofs that are sound but tired. Across North Arlington and nearby communities including Kearny, Rutherford, East Rutherford and Secaucus, metal roofs on farm buildings and shops are frequent coating candidates, and timing matters, since rust holes rule out a simple coating.
For metal roof coating in North Arlington, NJ or nearby towns like Kearny, Rutherford, East Rutherford and Secaucus, call (551) 348-7205 to reach a roofer who covers your street.
What the local climate does to a roof
Cold winters bring snow, ice and a long stretch of freezing nights. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, building ice dams that push water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in North Arlington is busiest after a hard winter and before the next one.
Why call
Why not wait
Drier ceilings
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Local knowledge
Local roofers see the same roofs and storm damage across North Arlington and nearby towns.
Clear next steps
Ask the roofer about the cause, the options and the estimate before work starts.
Metal Roof Coating questions
What type of coating works on a metal roof?
Acrylic and silicone are the two most common coatings for metal roofs. Acrylic is flexible, reflective and easy to recoat, and it suits sloped roofs that drain well, while silicone handles ponding water and sun but only bonds well to more silicone later. A roofer can help choose based on slope and weather.
Which metal roofs should not be coated?
The best candidates are structurally sound roofs with surface rust, faded paint and leaking fasteners or seams. Roofs with widespread rust-through, rotten purlins or loose panels should be repaired or replaced instead. Call (551) 348-7205 to have the roof evaluated.
How long does a metal roof coating last?
The life of a coating depends mostly on its thickness and type. Recoating at the right time adds years without redoing the prep. An inspection every year or two tracks coating wear.
Can a roof coating fix metal roof leaks?
A coating system seals fastener heads, laps and seams, which is where most metal roof leaks begin. Rust holes and loose panels have to be repaired first, since a coating will not span a hole or hold a loose panel down. An inspection shows whether a coating will solve your leaks.
Should I paint or coat my metal roof?
The difference is thickness and purpose: paint protects and colors, coating waterproofs. Choose a coating for leaks and paint for appearance. Either way, cleaning and rust treatment come first.
More questions? Call (551) 348-7205
Often needed together
Metal Roof Repair
Repairs for leaking fasteners, open seams, rusted panels and failed flashing on a metal roof, without replacing panels that are still sound.
Learn moreRoof Coating
Silicone, acrylic and other liquid coatings that renew aging flat, low-slope and metal roofs, after the seams and blisters are repaired.
Learn moreCommercial Roof Coating
Silicone, acrylic and other elastomeric coatings for commercial roofs, applied after repairs and cleaning.
Learn moreMetal Roof Inspection
A close check of the fasteners, seams, finish, trim and flashing on a metal roof, with findings ranked by urgency.
Learn more
Looking for something else?
See all roofing servicesGet metal roof coating help in North Arlington
Call (551) 348-7205 for a local roofer in North Arlington and nearby towns.