Seam repair
Peeling seams are cleaned, primed and taped along their full length.
Flat Roofing
Rubber Roof Repair North Arlington, NJ
A North Arlington roofer who works on EPDM can fix peeling seams, punctures, blisters and membrane shrinkage at walls and curbs, without the tar patches that damage rubber. One call to (551) 348-7205 reaches a nearby rubber roof repair pro.
Rubber roofs fail in a few predictable places. Seams lead the list, since older EPDM roofs were often seamed with liquid adhesive that breaks down over time. Punctures and failed flashing at walls, curbs and vents round out the usual causes.
Shrinkage is a problem specific to rubber roofs. The membrane pulls away from walls and corners as it shrinks, stretching the flashing until it splits. Repairing shrinkage means relieving the strain and reflashing, not smearing sealant on the split.
Avoid one common shortcut before the roofer arrives. Asphalt roof cement, tar and many general purpose sealants contain solvents that soften and swell EPDM, and nothing made for rubber will bond over them later. Instead, catch drips inside, stay off the roof when it is wet and note where stains appear.
If the problem goes deeper than it first looked, a North Arlington roofer may also recommend rubber roof installation or flat roof repair.
Looking for North Arlington rubber roof repair? Call (551) 348-7205 to reach a nearby roofing contractor.
Call nowThe process
How rubber roof repair works
Here is how a roofer usually handles a rubber roof repair.
Inspect the roof
The inspection traces the leak from the stain back to seams, flashing and penetrations. Wet insulation under the leak is checked with a moisture meter or a small core.
Clean the rubber
Old rubber is washed and scrubbed until the surface is clean and dry. Any old tar or asphalt patch is removed first.
Apply primer
Primer goes on in a thin, even coat over the cleaned area. Skipping primer is the most common reason patches peel.
Apply the patch
Peel-and-stick EPDM cover tape or a cured patch is cut with rounded corners, pressed down and rolled firmly with a seam roller. Corners and penetrations use flexible uncured flashing.
Reseal the seams
Open seams are cleaned, primed and covered with seam tape or a cover strip along their full length. Lap sealant protects the edges.
Reflash the walls
Where the rubber has pulled away, the roofer relieves the tension, adds new flashing up the wall and secures it with termination bar. The top of the flashing is fastened and sealed.
What is included
What rubber roof repair covers
Penetration flashing
Pipes and vents get new rubber flashing sealed at the base.
Surface renewal
A rubber-compatible coating can follow repairs once all leaks are fixed.
Tear repair
Holes and tears are patched with EPDM cover tape that extends past the damage.
Shrinkage repair
Membrane pulling from walls is released and reflashed to stop tears at the perimeter.
Related service
EPDM Roof Repair North Arlington, NJ
Repairing EPDM is simple in concept but unforgiving of shortcuts. Dirt, moisture or skipped primer are the usual reasons an EPDM patch fails. Lap sealant finishes the edges.
Weather matters for EPDM repairs in North Arlington, since primers and adhesives need dry conditions and mild temperatures to bond. Short-term fixes can protect the house until the weather cooperates. Temporary seals are not a substitute for a primed patch.
Related service
Rubber Roof Replacement North Arlington, NJ
There comes a point where patching an EPDM roof stops being worth it. Seams failing all over, shrinkage pulling at every wall, a brittle and crazed surface or wet insulation across large areas all point toward a new roof. A moisture scan shows how much is still dry.
Replacement options include new EPDM or a heat-welded membrane like TPO. If the existing roof is a single layer with dry insulation, a recover may be possible, but wet insulation means a tear-off. Ask the North Arlington roofer to compare repair and replacement for your roof.
Local help
Rubber Roof Repair Near Me
Rubber roofs in North Arlington cover many porch roofs, additions, garages and flat sections on older homes. Across North Arlington and nearby towns like Kearny, Rutherford, East Rutherford and Secaucus, older rubber roofs most often need seam and shrinkage repairs, while newer ones mainly need puncture and flashing fixes, so a check after big storms is worth it.
Need rubber roof repair around North Arlington? Call (551) 348-7205 for a North Arlington roofer who serves the towns around it too.
Roofs in this climate
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, which is how ice dams form and back water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in North Arlington is busiest after a hard winter and before the next one.
Why call
Why act early
Less damage
Small roof problems caught early usually stay small repairs.
Familiar with local homes
Local roofers see the same roofs and storm damage across North Arlington and nearby towns.
Clear next steps
Ask the roofer about the cause, the options and the estimate before work starts.
Common questions about rubber roof repair
How is a rubber roof patched?
The surface is cleaned, primed and covered with rubber patch material. After cleaning and priming, a peel-and-stick EPDM patch is applied and rolled. Lap sealant finishes the edges.
Why is my rubber roof pulling away from the wall?
Aging rubber contracts over time. As it shrinks, it pulls on the flashing, stretches across inside corners and can tear at the wall. Repairs release the strain and reflash the wall.
Should I coat my EPDM roof?
A coating can extend the life of aging EPDM. Repairs and a compatible primer come first, then the coating. Coatings do not fix wet insulation.
What is the lifespan of an EPDM roof?
A well installed EPDM roof commonly lasts 20 to 30 years. Thicker membranes, good seams and regular inspections push it toward the longer end. Fixing small problems early protects the rest.
Is roof cement safe for an EPDM roof?
Roofing tar and roof cement are not compatible with EPDM. The petroleum in them breaks down rubber and blocks real patches from sticking. The right fix is a primed EPDM patch.
More questions? Call (551) 348-7205
Often needed together
Rubber Roof Installation
New EPDM rubber roofs laid in wide sheets over insulation and a cover board, with primed and taped seams, so the roof stays flexible and watertight for decades.
Learn moreFlat Roof Repair
Fixing open seams, blisters, splits, ponding and failed flashing on flat and low slope roofs, after the real leak source is found, not guessed.
Learn moreRoof Coating
Silicone, acrylic and other liquid coatings that renew aging flat, low-slope and metal roofs, after the seams and blisters are repaired.
Learn moreRoof Leak Repair
Finding where water gets through the roof and sealing it at the source, so the stain on the ceiling stops growing.
Learn more
Looking for something else?
See all roofing servicesTalk to a North Arlington roofer about rubber roof repair
Call (551) 348-7205 for a local roofer in North Arlington and nearby towns.